Suspension Attaching Holder Compatible Microphone Review

A word of advice: do not use the screws provided. These are typical "cheap" quality screws that everyone includes for free. Use a strong drywall or other screw of a certain length and IT WILL be strong! OMG love this thing.

Small waste. - A good design idea that I can copy and build properly. However, THIS product is a waste of money. - Take the money you would pay for it and light it up and when it burns out you have something that will last longer than this product. The lever that screws onto the back of the mounting plate broke before I could mount the bracket. - It's not even charged. - This company/type of vertical mic mount is useless and when I requested a replacement or refund I was immediately told that…

This mount is reasonably priced, but it is one of the few wall mounts for an arrow. like this. First thing I would do if you get this pre-install or if you already have it and the damn hand is about to fall off or has already fallen off, grab the Gorilla Glue! Where a cheap arrow stand used to screw this into the bracket, put a few turns of tape over the two screws. After that apply gorilla glue to both the boom arm mounting plate and the screws, oh and please use a torx screwdriver set if you…

I was so excited when I got the wall mount that I immediately started just marking and drilling To discover this: 1) the hole the suspension arm was supposed to fit in was too small (could fit it in, but not very far - and yes, I completely removed the silver screw that was supposed to tighten the fit) for my innoGear arm.2) supplied screws and 'anchors' don't really help much to hold the thing to the wall. On my first attempt to adjust the wishbone, it just slipped off the wall. To solve this…