TCP Global Adjusting Regulator Pnuematic Review

Adapter could not be screwed on because the threads showed manufacturing defects immediately after unpacking. The regulator cannot be fine tuned and will fall off completely if you try to adjust it below 20psi.

I used this and it didn't work when I tried to use it after very few tries it fell apart due to cheap materials and construction. You will waste your time and money trying this product.

Misleading. Had to believe other 1 star reviews. No regulator, just an on/off valve showing the pressure at the compressor. Mine even came with damaged threads. Back if possible

pos. The listing title says 1/4 NPT. embedded at the end of the description it says its thread is 1/4 nps. totally incompatible with all the pneumatic fittings, hoses and spray guns I bought this thing for.

My second attempt at this product. First, the pressure gauge was glued "under" the small bottom bar. so I couldn't get up. With this replacement, the gauge is now stuck at 80psi. Won't give in. I suggested that Revain remove him from their lists. It's not worth the hassle of picking it up and bringing it back.

This regulator worked fine the first few times. But then it got unpredictable. I use a feed regulator set at 60psi and that regulator is set at 20-30psi depending on the job. Once installed, the pressure goes everywhere. Sometimes it goes as high as 40psi so I drop it down to 25psi. It then drops to 10 pounds per square inch and sometimes to almost zero. I reset and the game starts again. Every 2-3 minutes I find myself building this thing. I ended up taking it off and throwing it in the trash…