Timex Resin Watch Strap Color Review

Fits my Casio as advertised. The plastic is flexible and soft, maybe too soft, but we'll see how it holds up. The design goes well with old school/traditional Casio digital watches. My only complaint so far is that the color and texture aren't perfectly consistent. There is a small streak (about a millimeter wide and about an inch long) on one of the straps that looks like a dirty or greasy stain, but that's just a flaw in the plastic.

Was looking for a replacement for my Timex Expedition sport/digital watch. I'm not 100% sure on the model name, but it also has Indiglo. I needed an exact replacement for the original strap (it looks gray with a resin weave). I couldn't find it so I bought it based on other reviews that said it would fit my watch. The band looks like it would match the watch. Getting dressed was a bit difficult.

The one I received does not fit a 7-3/4 inch wrist, maybe 8 inch if snug. For wrists larger than 7-1/4", the small loop holding the end of the strap tends to leave the "pointy" end protruding from the strap so it can be attached to clothing etc. I had to use a sharp knife Cut the material near the pins to fit my old Timex Ironman but it was easy.

The original watch strap was hard and uncomfortable, pressing on the wrist and lifting the watch off the wrist. This watch strap fits my wrist well allowing the watch to lay flat and wrap comfortably around my wrist. Like other reviewers, I had to snip about 1/16 inch from both sides of each strip with a utility razor to allow it to move freely. I didn't have to cut where the pins go, they fit perfectly. This watch strap looks and feels great! That's exactly what I wanted.

I bought this watch strap from Timex to replace the 18mm strap on my Casio W-201. Watch straps for Casio watches are expensive, sometimes exceeding the cost of new watches. So I decided to try this cheaper tape. This 18mm strap is advertised for Casio watches. However, I had to cut some material at both mounting points to mount it to the clock. The mounting points do not have enough relief to fit the watch case. Pretty simple procedure, but I wasn't expecting it.