TOLESA 9 Inch 14TPI Heavy Metal Cutting Reciprocating Saw Blades - Bi-Metal Sabre Saw Blades For Metal Pipe, Sheet Metal, Rebar, And Cast-Iron - Better Wear Resistance - 5 Pack Review

I got these for a plumbing project that required me to cut out some galvanized pipe along with some other fittings. I did fine for the other metal fittings but I went through a whole blade on one piece of galvanized pipe. They got hung up once but that was my fault. Overall they worked well enough for my project but I went through three blades with four cuts

I don't know if it is reasonable to expect to be able to cut through more than 1 1/2 rebar (1/2" thick) before the blade needs to be changed but, 1 1/2 rebar per blade is my experience.

did not do the job I bought it for - not fast cuttinglike some brands on amazon - dont trust a product unless you knowthe brand and know the quality !

These blades worked perfect with my Milwaukee sawzall to prune this out of control bush/tree thing (don't ask because we don't know what it is) we have growing in our yard.

Used to cut through aluminum rims. Worked well but needed tougher blades. Surprised blades lasted as long as the did cutting through the metal

this deal makes no since for how good the quality and the quantity of items we are getting they are basically santa clause

Pretty good saw blade, I cut thru a few nails with them, they'll get the job done but like always you'll still go thru blades, as far as cutting lumber they're not to bad. But when it comes to cutting with blades it helps to remember they all get dull eventually.

I went through 3 blades in short order while doing a demo on a small deck and hot tub. All 3 blades snapped at the shank. I was doing the demo with a recently purchased DeWalt reciprocating saw. I switched to my DeWalt blades to complete most of the demo on the deck.

These blades work good for demolition of the bathrooms I remodel.Cuts through fiberglass enclosures nicely. The blades may produce excessive heat during use, causing the metal to warp or bend!

Bought this to demo a door rough in opening which was too small. I needed to get between the stud and the sheating to cut the galvanized sheathing nails around the door so that I can surgically remove the studs and replace them to build the correctly sized opening. These blades were perfect for the job. It made quick work of getting in between the sheathing and the studs and also between two studs that were nailed together to cut the nail that was holding them together.It was easy to get the…

I guess I should have known that the quality would not be great because of the price. Used all the blades on one project.I have to add to this that the manufacturer got back to me immediately and offered a new set of blades for me to try. I admire the customer service that is responsive.I would definitely try their products again.