Put up by myself in minutes, have some air bubbles that I couldn’t get out with my shower squeegee but it’s effective at delivering privacy without totally blocking light entry! Time will tell how well it stays stuck to the window! Smells a bit strong (think inflatable pool floaty) but should fade with time. Easiest DIY ever!

It was very easy to apply. The instructions say to cut it 1” larger than the size needed…I found it worked better if I cut it to size.

The film was very easy to cut and apply. I did have a slight problem getting some of the edges to stay down after the film water was squeegeed off, it appeared as if the edges did not stick after a few days. After speaking with customer service they provided some solutions and were very helpful. Great privacy film.

Did see a tip on how to peel backing from the actual film, which is kind of tricky. Place tape on either side of the corner which you are trying to separate the film from backing. I used heavy packing tape, not scotch tape. It helped to start off the process.

So glad I waited until I had help putting this up. Two of us struggled for at least half hour to get it on right. Used it on shower glass "wall" panel, had to cut around 3 of the glass fasteners. It stuck pretty well but we had to keep misting it with water and it was easy to accidentally pull back and have to re-wet and swipe with (old driver license, credit card etc.) straight edge to push out bubbles. After all was said and done, there's a strip down one side it is showing bubbling even…

I liked how easy it was to trim, to install, and how it’s frosted finish allows privacy, yet still allows light to pass through.