📡 TRENDnet 2.4/5 GHz Outdoor Dual Band Omni Antenna Kit, N-Type Male Connectors, Supports 802.11ac/n/g/b/a Routers And Access Points, White, TEW-AO57 Review

Indoor use with Mikrotik Routerboard RB2011UiAS-2HnD-IN. I expected a significant difference between these and the factory antennas. Although I noticed an improvement it wasn't groundbreaking but they are helping. Still very good quality and very attractive!

So I bought several sets of these antennas and used them with Meraki MR62, MR72 Access Points. They seem to have decent signal strength and are holding up pretty well from the outside. I've never had to replace it. They offer excellent value for money compared to Meraki brand antennas which cost over $100 for a set of 2. Would buy them again.

These antennas on the UAP-AC Mesh Access Point with the appropriate adapters work great. I needed a custom solution where Ubiquiti's own antennas weren't working, I needed omnidirectional antennas in a specific form factor. For the UAP-AP Mech here are the adapters, they are well made too. DHT Electronics RF Coaxial Cable Assembly RP-SMA Male to N Female Bulkhead 12'

I had this product for a day and the antenna was broken. It was outside in my apartment and was not exposed to any outside influences other than the usual. It was mated to a Meraki MR76 and while it worked well it was incredibly fragile. I've tested this on Meraki, Cisco, AccelTex and Tessco models and there was no endurance comparison, it's Class A rubbish. Stay away unless you intend to repurchase regularly.

I had this product for a day and the antenna was broken. It was outside in my apartment and was not exposed to any outside influences other than the usual. It was mated to a Meraki MR76 and while it worked well it was incredibly fragile. I've tested this on Meraki, Cisco, AccelTex and Tessco models and there was no endurance comparison, it's Class A rubbish. Stay away unless you intend to repurchase regularly.

So I bought several sets of these antennas and used them with Meraki MR62, MR72 access points. They seem to have decent signal strength and are holding up pretty well from the outside. I've never had to replace it. They offer excellent value for money compared to Meraki brand antennas which cost over $100 for a set of 2. Would buy them again.

These antennas on the UAP-AC Mesh AP work great with the right adapters. I needed a custom solution where Ubiquiti's own antennas weren't working, I needed omnidirectional antennas in a specific form factor. For the UAP-AP Mech here are the adapters, they are well made too. DHT Electronics RF Coaxial Cable Assembly RP-SMA Male to N Female Bulkhead 12'

Indoor use with Mikrotik router board RB2011UiAS-2HnD-IN. I expected a significant difference between these and the factory antennas. Although I noticed an improvement it wasn't groundbreaking but they are helping. Still very good quality and very attractive!