Header banner
Revain logoHome Page
πŸ› οΈ uxcell woodworking milling cutting bearing logo

πŸ› οΈ Uxcell Woodworking Milling Cutting Bearing Review

3

Β·

Average

Revainrating 4 out of 5Β Β 
RatingΒ 
3.8
πŸͺš Router Bits, πŸ”ͺ Cutting Tools

View on AmazonView on Π―M

Media

(4)
img 1 attached to πŸ› οΈ Uxcell Woodworking Milling Cutting Bearing
img 2 attached to πŸ› οΈ Uxcell Woodworking Milling Cutting Bearing
img 3 attached to πŸ› οΈ Uxcell Woodworking Milling Cutting Bearing
img 4 attached to πŸ› οΈ Uxcell Woodworking Milling Cutting Bearing

Description of πŸ› οΈ Uxcell Woodworking Milling Cutting Bearing

Shank Diameter: 12.7mm / 1/2"; Cutting Diameter: 12.7mm / 1/2". Cutting Depth: 78mm / 3 inch (approx.); Total Length: 129.4mm / 5.09 inch; Material: HSS. Solid hardened High Speed Steel body with anti-kickback design. Can be used without the bearing as a standard straight bit, great for combined plunge-cutting and pattern/template routing. For increased work piece visibility, use shank bearing flush trim bit in a handheld router allowing the template to be positioned on top of the work piece.

Reviews

Global ratings 3
  • 5
    0
  • 4
    2
  • 3
    1
  • 2
    0
  • 1
    0

Type of review

Revainrating 4 out of 5

Efficiency in Woodworking

This router bit has made my woodworking projects more efficient than ever before. The sharp edges cut through the wood with ease, leaving clean and precise cuts. It has also held up well after multiple uses. However, the only downside is that it tends to produce a lot of sawdust, so I recommend wearing a mask or working in a well-ventilated area. Overall, this router bit is a great addition to my Industrial and Scientific cutting tools collection.

Pros
  • Can make precise cuts in woodworking projects
Cons
  • Requires skill and experience to use effectively

Revainrating 4 out of 5

Acceptable cut quality

Of the two nozzles ordered, one was slightly unbalanced, causing more vibration than I was used to. However, the cut quality was acceptable.

Pros
  • For better work piece visibility, use a flush end mill in a hand router to position the template over the work piece.
Cons
  • Obsolete model

Revainrating 3 out of 5

Bearing lasted no more than 20 minutes

bearings will fail sooner or later. Whenever I can, I use a fence as well as a camp. but this particular cut would not allow it. and I'm used to bearings that work maybe five hours. This fell apart after about 20 minutes of use. If I worked on furniture I would be very angry. I did clean the edges of some decking boards though, so I may be the only one who has ever noticed the ruined edge. and I could use a stock from another router to finish the job. However, there are different quality camps…

Pros
  • Rugged, hardened high-speed steel housing with anti-kickback protection.
Cons
  • Slightly cracked