High-Quality uxcell Car Spark Plug Wires Set for Volkswagen 1946-1979 09001 - Ignition Cable Wire Kit for Enhanced Performance Review

No misfires after installation but a boot was torn and they are too long to install on the sides of the engine without additional wires.

I have a 1964 fault and these wires stay on the spark plug. I installed new Bosch cables that are not attached to the lock and they just came loose from the spark plug from engine vibration.

plugs didn't fit my '65 Beetle spark plugs. They were too small. Wires generally feel of very poor quality. I don't think the rubber surrounding the wires is heat resistant at all.

VW cable set. The coil and 3 of the 4 were fine but 1 wire on the end of the spark plug was unfinished. Not only was it missing a clip, it also lacked the holes needed to hold the clip. I immediately had to exchange the old terminal for a new cable.

they will not fit my 1971 VW Beetle air cooled engine. In short, I have no idea why. Now I have sent them back and they emailed me asking me to return them. So now they're lost somewhere between my house and where I was supposed to send them to, which means I'm not receiving my money, which sometimes seems to work.

The cables install easily and are long enough for a clean fit on a flat or vertical motor. Have a wire hanger and electrical tape handy to route the wires behind the base of the generator. One wire at a time to avoid wrong installation. The covers on the ends of the wires are part of the cooling system and must fit snugly against the sheet metal. When installing new gaskets, do not thread the aluminum plugs provided onto the ends of the plugs.