🔌 VCE UL Listed 5-Pack CAT6 Keystone Coupler RJ45 Female to Female Ethernet Insert Jack UTP Network Inline Connector - Blue - Enhanced SEO Review

Honestly they make this thing FAT! I can't for the life of me get it to fit the wall board I'm using. It's a little too thick, and the clip on it could very well be granite. it's so hard Maybe with time I'll manage to slide this into the wall plate, but so far it's been a nightmare.

Bought 2 packs of 5 so far 5 used and one of the 5 was bad. I ran a cable through my attic into a patch panel and then into a switchboard and got disconnects and very slow 20Mbps speeds. I tried replacing everything in the chain except the adapter as I didn't understand that a bad adapter could result in slow speeds. I figured it just wouldn't work so that was the very last thing I checked. I wasted a good hour and a half of my time with a bad Keystone clutch. As soon as I replaced it with…

If you want to get upset, get angry and have a bad day; buy this shitty product. Extremely difficult to install on a wall plate without modifying the ethernet port. That means clamping the insert's clips and even gluing is required if you want it to stay in place. THIS IS SIMPLY STUPID AND DO NOT SPEND YOUR MONEY.

They are very easy to install and are ideal for installation with existing RJ-45 sockets. However, I had trouble getting them in and out of the trapezoidal stone wall panel. Snap broke when I tried to temporarily delete it

I bought these connectors to replace the unreliable ones from Monoprice which have accidentally lost connection over time. Once installed, these CAT6 connectors are strong and reliable. No problem. Highly recommended.

When I wired my house over a decade ago, I used keystone jacks, which were a knockout for the best Cat 5e at the time cables required. I had a couple of jacks that didn't connect at full speed. When I saw them I decided it was worth a try. I tried another brand from another supplier and had to return them when they didn't work properly. With them, my network speed is where it should be. They were cheap and delivered quickly.

It's quite comfortable. I've run ethernet through multiple walls, and the ones that require you to create your own termination (starting with bare wires) are pretty annoying. That being said, I can just take whatever ethernet cable I have, run it through the wall, and make a wallboard out of it. And I can easily make a difference in the future because they also easily switch off. Good product.

I was looking for a way to run one of my ethernet cables through the wall into an existing multifunction outlet in the next room. This Keystone CAT6 jack was just what I needed! It fits easily but securely into an empty slot on the exit panel (satisfactory locking). I could then just plug the shorter CAT6 cable into the other (wall) end and voila, done. There is no need to laboriously rewire many signal wires in a normal Ethernet cable – a job that is probably beyond my talent and experience…

bought 2 packs of 5, I've already used 5 and one of 5 was bad. I ran a cable through my attic into a patch panel and then into a switch and also got disconnected at very low speeds of 20Mbps. I tried replacing everything in the chain except the adapter as I didn't understand that a bad adapter could result in slow speeds. I figured it just wouldn't work so that was the very last thing I checked. I wasted a good hour and a half of my time with a bad Keystone clutch. As soon as I replaced it with