🛵 Yamaha VX 110 / VX Sport / VX Deluxe - 2005-2009 Seat Cover Review

Installed last night. Two took about 1 1/2 hours to make. We really took our time and used an air compressor stapler. You look fantastic. Fits well. Can't say anything about durability yet, but they seem very thick and sturdy. Flexible enough to install easily, but not flimsy.

Super, my wave runner looks like new again! It's not that bad to install it yourself. I took my time and mostly used a pneumatic stapler. I also liked how I could put it on top of my old seat cover without having to remove a few hundred staples first. My old seat upholstery was mostly intact so I was able to do this. If yours is too torn you can remove it from the foam first.

The cover worked well and appears to be a good cover. We'll see how it holds up. This takes quite a while to get on and I highly recommend an air or battery powered stapler with a point that goes under the staple guide to get in the gap where the staples go. I removed all the cover and brackets and it came out pretty good. Much easier to put on when the cover is warm and there are two of you!

I've upholstered before but it turned out to be more difficult than I expected. I didn't get sunlight so put it in the dryer first to soften it. However, it cooled down quickly, so it didn't work very well. I had a hell of a time to tighten it up. I would recommend doing the work outside in bright sunlight so it stays warm and relatively soft during installation. The material is thin which is better for shaping and indeed for recovery. I left the old cover on and taped some of the holes as…