🔌 ZOOKOTO 0/2/4 Gauge to 4/8/10 Gauge Car Audio Power Distribution Block Splitter with 2 Way Outputs, Fuse Holder and Power Distributor Review

I have 4 door speakers each drawing 90-100w RMS at full load (no distortion) and 2 flat mount subwoofers each pulling up to 250w RMS and everything is powered by both a Pioneer GM 8704 and a 750 W RMS NVX monoblock amplifier. No problem connecting two amplifiers with this splitter. I have 4-gauge-8-gauge connectors that are less than 4 feet long each, so I get plenty of power without sacrificing distance. Great device if you want to keep your cord tidy and only have one power cord connected to…

That's OK. Wouldn't buy again. The connectors are not well connected to the base. It seems to have loosened but hasn't fallen off. Using an ohmmeter, verify that no resistance is being added by the splitter.

Just what I need to power 3 amps in my car. A much better solution than running 3 separate battery cables and cheaper. I only had to connect a 0 ga cable to this unit and then 3 smaller gauge cables to the amplifiers located a short distance away. I will buy another one to bring all the bases together because it will eliminate the clutter and I only have to drill one screw hole on the chassis.

I have 4 door speakers each drawing 90-100w RMS at full load (no distortion) and 2 flat mount subwoofers each pulling up to 250w RMS, all powered by a Pioneer GM 8704 and a 750W RMS NVX monoblock amplifier. No problem connecting two amplifiers with this splitter. I have 4 gauge plugs with a transition to 8 gauge plugs that are less than 4 feet long each, so I get plenty of performance without loss due to distance. Great device if you want to keep your cord tidy and only have one power cord…

Really as advertised. The grommets tightened and secured my wire and it came with screws to secure it. What else do you need? :)