Review on π§ Streamline Metalwork Fitting Reducer Splicer: Maximize Efficiency and Precision by Jeffrey Sanders
The size is NOT as advertised!
notches 5-6.5mm advertised. Actual size is 4.5mm to 6.5mm. Was planning to use them to replace the 5mm fuel line on my vintage car with a 1/4" but the fit is so loose it could be dangerous. These notches are not as advertised so completely useless to me.
- hose fittings
- small parts
New products
Comments (0)
Top products in π§ Fittings
Joywayus 5/8" ID Hose Barb Hex Union Brass Fitting Water/Fuel/Air With 10 Stainless Steel Clamps (Pack Of 5)
13 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
6 Pack Miahart Adjustable 304 Stainless Steel 4 Inch Hose Clamp Duct 91Mm-114Mm Worm Gear Pipe Clamp For Automotive, Mechanical Agriculture.
18 Review
DIGITEN DC 12V 1/4" Inlet Feed Water Solenoid Valve Quick Connect N/C Normally Closed No Water Pressure
14 Review
