Review on 🖥️ VIVO Adjustable White PC Mount - Under Desk & Wall Computer Case Holder with 135 Degree Swivel - MOUNT-PC01W by Mark Estrada

If it's mainly going to be mounted on a hollow table like Ikea or similar I wouldn't use molybdenum screws. Cut a larger piece of 1/2 ply (15/32 ply is most common at Home Depot) or OSB that allows for general-purpose wood screws and more surface area for wood glue to glue. Lay it out and then pre-drill the layer for the screws. Apply wood glue generously and then screw on. All around and across the material is 1/2 inch. You can't overdo it. I used #9 screws and a 1/8" straight drill bit. Almost any wood screw will do, but PRE-DRILLING is a must. Pre-drilling prevents 1/2" stripping when the tip of the screw hits the table pulls the material and adhesive onto the table surface Set the drill or screwdriver to low torque Once the screw enters the table Step back and use a hand screwdriver so as not to dislodge what little material (hollow table) she bites into The glue adds strength as directed, no molly bolts, bends easily but in no way falls down without a fight.