Review on Camco 25252 Vinyl Trim Insert (3/4&#34 by Wagner Witlin

There were no instructions so I had to learn everything myself. You should know that the window glass replacement tool will help you with that. Use the bowl side of the tool. Once you've gotten four to six feet, you should get comfortable. The wheel groove sits on the edge of this material and maneuvers into place. Put your hand on the camper and don't push the wheel in too deep to avoid the screw heads. Run straight to the path to clean the screw heads. Stabilize again by resting your hand on the RV, the tool at about a 45 degree angle, maybe 1/8 inch into the groove. If you go deep and run over the bolt head you lose your bead and start shallower from there. If you do it right, it goes very quickly. Be patient for the first ten feet and you will get there. Start right and left if you're right-handed. This should be done on a warm day. I waited until the end of May. 75F. On a cool 50 degree day I tried in April it was too harsh. Leave the old material and use it to measure the required length from the large roll. Allow yourself about 6 inches more as your original is likely shrunk and you can trim when you're done. Start with about an inch more as it can slip a little and is easy to trim. Don't be afraid to cut and leave 1/4 inch as it will shrink back down in a few months. If only someone would tell me all this! Much luck!