Review on 🔧 Timken SP500300 Axle Bearing and Hub Assembly: Ultimate Performance with Blue-Connector Passive Sensor by John Bourgeois

Bought two to replace the originals with 225k on them, one of the originals started making a clicking noise and disassembled it for ball joints (also originals ) anyway. Came in Timken boxes, US Timken stamps. Revain and Timken have done it again! The installation went as expected without any problems. Buy with confidence. The only reason I didn't give them 5 stars is because I only rode them 5 miles. TIP: Typically, when removing the old sensor wire, the tab on the upper arm will break a hole. The hole goes through the control lever. Just drill a clean hole to pry out the plastic and make room for the new Timken hanger as it has the same new grommets as the original. GTG