
good I have a computer that needs 6 fans 2 of the standard fans died and one started making noise so I decided to get new fans and buying these mounting rivets and well sometimes it was easy to install the rivets, sometimes it was difficult or they broke, then I noticed that there was more gap on one side than the other, I started to see a big gap on the fan side and there were no more problems because as a test i put rivets on a noisy dying fan and they worked fine even with a few broken ones i still have many they can only keep a standard fan with 2 i personally have with 4 built but good to know if you have more fans or make multiple systems

M.2 Screw Kit: Easy Mounting for NVMe SSDs on ASUS Motherboards
19 Review

🔩 RION TECH 4 Pack Rubber Case Feet + Set of 10pcs Repair Replacement Screw + 1pcs 5 Point Pentalobe Screwdriver for MacBook Pro Retina A1425 A1502 A1398 13-inch 15-inch Bottom Case (Retina)
10 Review

🖥️ Helifouner 450-Piece Computer Standoffs Spacer Screws Kit: Ideal for Hard Drive, Motherboard, Fan, Power Graphics & Computer Cases
10 Review

Comprehensive 500pcs Laptop Screw Kit Set for 🔩 IBM HP Dell Lenovo Samsung Sony Toshiba Gateway Acer
12 Review

🔌 UCTRONICS GPIO Breakout Kit for Raspberry Pi Pico - Assembled Pi T-Type Breakout + 830 Tie Points Solderless Breadboard + 40 Pin Male-Female-Male Rainbow Ribbon Cable + 65pcs Premium Jump Wires
10 Review

DSD TECH 2 PCS IIC OLED Display 0.91 Inch: Perfect Arduino ARM Accessory
9 Review

Neural Compute Stick 2 by Intel
12 Review

CZH-LABS Electronics-Salon Prototype Shield Kit for 🛠️ Raspberry Pi - Ideal for Breadboard DIY Projects
13 Review