Review on 🔌 iKKEGOL 16 Pin J1962 OBD2 OBD-II Male Connector to Open Plug Wire, OBD Diagnostic Extension Cable Pigtail - DIY (60cm, 24 inch, 2ft) by Tony Wilson

This product is universal, it will work as a replacement for any OBD2 connector when properly connected. Most cars only use half the cables or so that an OBD2 port is available, so don't feel overwhelmed. I read reviews that the wires don't match the diagram in AD, maybe this is the case with some devices, but everything was correct for me (checked before installation). Be sure to solder the wires and use heat shrink tubing to protect them. This is not a part you will ever want to deal with again. The port itself is high quality, I wish the manufacturers had used a port at least half the strength of this one. Also be prepared to be in a very uncomfortable position for about an hour while soldering it in, NO FUN! This is not the product's fault, just the under-dash location of most OBD2 ports.