Review on 🔧 Optimized Stainless Engineering Architect for Machinist Engineers by Matthew Fadoul

These rulers are great, I lost my first ruler in 3 years in the bottom of the sawdust and coolant container; I've been looking for this thing for a few hours, even stayed after work to check. I used it every day at work for welding and machining. So I had to buy another one. I felt naked without him, I found myself reaching out for him when I needed him; and if it wasn't theirs, I was sad. So I had to buy more, this time I took two packs in case it happens again. They are very good quality, nice and thick, sturdy and have some really nice lettering. I haven't noticed any fading (except for scuff marks) in the 3 years I've had my first one. I ran this thing through a ring, I used it to line up two pieces of metal as a ruler. Sometimes I accidentally grabbed it on the part I was welding so I had to take a grinder to remove the burr from the welder. I've dropped it on the floor almost every day, but it has never bent, cracked, or broken. It's small enough to fit in my left front pocket of my uniform, where I keep my pens and pens because I'm right-handed. It has 1/8" and 1/16" pitches at the front and 1/32 and 1/64 at the back. Everything is accessible and easy to read. Sometimes I had to use a flashlight to get accurate measurements for the '64s, but who doesn't, they're just so close together no matter which way you look at it. I would recommend this line to anyone who wants it. Four kids in my editing class even bought a few, as did my instructor when he saw mine. 10/10 would buy again.