Review on Primelux Universal Wiring Harness Driving by George Halbohm

I bought this wire harness for my old Ford truck. They power the row of LEDs on the front panel. They work great and the wiring harness was easy to install. I was seriously impressed with the value this line represented so I bought a second line for my fountain. I replaced the dash on/off switch with a marine float switch and it works great. The magnet activates when the float switch is turned on to turn the pump on directly from the battery rather than via the float switch located ten feet below the water level. Pump. The only issue I had was that there is a nice solid plastic connector at the end of the wires coming from the solenoid. It fits together very well, but the two pins inside (which fit into the holes on the mating connector that has wires going to the headlights/pump) are too light. A pin burned out surprisingly quickly, even though the pump used less power than an LED matrix on a truck. I cut out this connector and soldered the wires together for a perfect connection. Since then there have been no more problems with the suspension. I also coated the connector plug on the other wire (to the switch) with silicone sealant to protect and hold them together if they are disconnected in one step. I doubt they're particularly UV resistant, so this seemed reasonable. Any problems are most likely related to the plugs as both of my problems occurred when I was attaching them to my fountain. The solenoid and wiring harness work great with the connector issues fixed. The wiring harness in the truck works great and stays intact. I recommend!