Review on 🚗 Upgrade Your Jeep Grand Cherokee with DNA Motoring HL-OH-JGC99-BK-CL1 Black Clear Headlights Assembly Replacement! by Wayne Drakh

Looks much better than the original I replaced. Fairly well aligned to the mounting points and have a decent, even light that's better than the old factory. They have some issues that I could easily have given less stars if the price wasn't so low. The biggest problem I had was the right hand low beam connector unscrewing during installation. Not a problem with the bulb, but with a thin body and a slightly enlarged hole that isn't obscured by the o-ring on the bulb. This allows moisture to get inside the case if I don't seal it somehow. I also had to loosen the screw holding the lower parking, marker, and turn signal reflector to seat the 3157 parking socket and turn signal bulbs, and then tighten the screw back against the socket, being careful not to block the glass break, but still tighten it. Although the packaging has paper dust seals over the lamp holes, there is still some dust inside, although you really only see it when the light is on. To set them up you have to plug and unplug them until they are set as they don't come with adapters that extend the adjusters to the hole that was used in the originals. They do not come with bulbs like similar headlights. To be honest I have not yet contacted the seller who would most likely offer to replace them as I doubt they will be different enough to offset the hassle of removing and sending them back. I work at a Chrysler dealership and I can tell you they are well under the price of Mopar headlights. If you don't expect quality genuine parts for a fraction of the price and can use a bit of tweaking, this should still be a good choice.