Review on 🔧 2-Pack SUNGATOR Brass Pipe Fitting Adapter, 1/2-Inch Male to 1/2-Inch Female Pipe by Deejay Allard

I was afraid to buy this device knowing it looked a little flimsy, but I was shocked to find the level of custom design. Yes, I tried anyway, because of course it was very difficult for me to set up the project, and yes, of course, my suspicions were immediately confirmed. and industry protocol. First let me say that the wall thickness of the adapters is so thin that they do not meet the requirements of a charting system. In other words, with a wall thickness of 1mm or less (see photo 2) they are LESS than graph 5 (see graph in photo 3) and are therefore not even considered valid. They literally don't exist as suitable fittings for any purpose. What this means for their functionality and your ten bucks is that you can't tighten them enough to prevent leakage without cracking or breaking them during assembly. You literally can't handle the torque it takes to tighten them properly (see Photo 1). This is a completely absurd construction, a waste of time and a waste of money. I knew better, now you know too.