So far, the impressions from the work are positive! The water pressure in my plumbing system is about 4-6 atm (depending on the time of day) . Therefore, I don’t bother with a boost pump yet, but I’m always ready to buy, because it’s not known what will happen tomorrow .)) Water in a 12 liter tank about 6-6.5 liters are collected in the storage chamber, about an hour and a half, with an overpressure in the outer chamber of the tank of about 0.5 atm (set according to the instructions with an auto pump) . For a family of 2 pensioners, this amount of water per eye, plus another A 100 liter aquarium is enough to strain for water changes! ) Added after 8 months of operation: Water quality has been stable for more than six months! 18-20 ppm out! Just super! I recently installed a booster pump so that there is always optimal water pressure at the membrane inlet - now 8 liters of pure osmosis are collected in a 12 liter tank in just half an hour ! Without a pump, no more than 6.5 liters were collected in an hour and a half, and the discharge of dirty water in the drains was twice as much! The effect and savings from the pump is obvious .)
NANPU 1 FRL Air Filter Regulator Lubricator Combo With 0-150 Psi Gauge, 5 Micron Brass Element, Poly Bowl & Semi-Auto Drain - Metal Bracket Included
20 Review
Filter under the sink Aquaphor Favorit ECO silver
20 Review
NANPU 1/2" NPT Air Drying System - 5 Micron Particulate Filter, 0.01 Micron Coalescing Filter, Air Pressure Regulator Combo - Semi-Auto Drain, Poly Bowl W/Metal Gauge
23 Review
NANPU Compressed Air Filter Regulator Combo: Brass Element, Semi-Auto Drain, 0-150 Psi Gauge, And More
21 Review