Review on CDI Electronics 113 4489 Evinrude 2 1988 1995 by James Thakur

The product worked but was very difficult to install. The installation required the destruction of the original charging coil in order to recover and reuse the metal plates. The kit should only come with the complete part. You'll need to pay close attention to routing the wires as they all move with the base plate. Directions are only written without photos to really help you. Nothing on their website helps, not the youtube video or anything. Stick to the original factory materials if you just want plug and play. This kit requires you to even splice the wires and insert the wires into the rubber connector. The instructions state that there are tabs on the motor to mount the power module. If you can't find them, they'll give you the mount to use. I also couldn't find a place on the motor to install it. I ended up tying the power module to an open area around the fuel pump. My original power supply lasted 30 years. I hope this setup lasts as long, if not I'll probably go with the factory original.