Review on 🔦 Xprite 7" Inch CREE LED Headlights for Jeep Wrangler JK/LJ/CJ/TJ & Hummer H1/H2, Halo DRL Round Headlamps, DOT Approved by Martin Dosunmu

*update* 21.10 thought one was burned out, it turned out the connector was loose, red fuse tab appears on the factory wiring harness, doesn't hold the jumper , although it was reliable. not correct. I tied two butts. ) I did a lot of research and research before I bought my flashlights. I chose her. I am completely satisfied. .The plastic tabs on the lantern and case mount are used to align the lantern in the correct position and not slide into each other. The DLR doesn't need to run a wire with a tap to the fuse box, I just hooked it up to the turn signal, there are three wires, one to ground, one to the turn signal, one to the low beam, that's going to be the middle wire, that's the one wire you press on. in. The only downside to this is that the parking lights have to be on to turn on the DLR, if you touch the fuse box in the key switch circuit the DLR will turn on every time you start the car or if you have an android app, where you can go in and change your computer's settings to your liking, you can turn your DLRs on and off, even if they're not available as an option for your car, the ability to do this is still inside the computer. Installing headlights is not a very difficult task, but apparently for some it is. So instead of criticizing someone's perfectly good product, you should just take it to a professional instead of trying to figure it out yourself and then blaming the product design for your inadequacy.