Review on Master Tailgaters Replacement For Ford F150 F250 F350 F450 F550 (1997-2007) Chrome Tailgate Handle With Backup Camera by Prem Robinson

Not quite right. The fillet is too round so it doesn't come out flush. The screws are about a mile away from being usable, making it impossible to align them properly. And there's a bar on the outer edge next to the camera that always prevents it from sitting flush. It's also made out of cheap plastic. If you try to tighten it to avoid it not being flush, the plastic will break. And it just looks cheap. It is flexible and pliable. Unlike the original handle which is nice and ribbed. Basically, they cut the cost by about 30 cents to give you a clean piece of junk. It would be better to get a stand along the camera and modify the OEM grip to accept it. You can use a 3D printer and tape to get a nice clean install. And you can install a much better camera. The camera is the same quality as most $20-$30 cameras. The quality of the pen is less than $30. The cable costs $5 to $10 or less. So expensive junk. Don't buy this.