Review on SUNLU PETG Filament 1: The Ultimate Additive Manufacturing Product by Brad Atl

Working on a large print when my Ender 3 Pro decided to go on vacation I switched to my CR10S which I set up for PETG with little success. After 2 failed prints I decided to try another thread before tweaking the machine further and this is where Sunlu White PETG comes to the rescue! ordered 1 roll to see if there was a difference and boy did it! My CR10S loves it! My settings are 240/70 and 50mm with a full metal hot end and it printed the perfect calibration cube. WITHOUT CHANGE! So I tried the fine print to test it more, BEAUTIFUL! then i increased the speed from 50mm to 70mm, again perfect print! So I started my long print, photos above, 1 day 15 hours 18 minutes later I had this swinging Civil War Captain America helmet with minimal stretch (and I mean minimal slight stretch) and clean lines throughout. So I tried my luck and printed a simple 2 piece 200mm x 300mm box, but this time at 70mm and a 150% speed increase. WOW! not missed. This is my new thread approach. SUNLU, as long as you continue to produce such quality, I am your obedient servant!