Review on 🚗 Enhance Your Toyota Camry's Interior with Xotic Tech Front Reading Dome Map Light Panoramic Roof Panel Cover Trim (Carbon Fiber Style: 2018-2021 Compatible) by Devin Jenkins

They look great but they weren't bent to fit the correct curve of the bumper and kept coming loose so I finally decided to use a heat gun to blow the plastic away soften and then bend it properly I used my own 3M double sided tape and now they hold properly. Second, the part that attaches to the bumper and runs between the air vent and the trunk lid was a bit too long. I had to leave a small gap between the taillight and the part so it doesn't hang down and stick to the trunk lid. If you zoom in on a photo, you will see a gap. When you finally apply them, first clean the surface well with an alcohol wipe. Then heat the surface with a heat gun or hair dryer, not very hot but lukewarm. Then attach a piece. It is best to do this in the garage with the door closed so that the wind does not blow dust onto the belt or back onto the surface that has already been cleaned. If he's in the car, give him some extra heat to heal him, then let him stand inside and cool off on his own. This will ensure the band stays in place and will not fall off. FYI, do not install the heat gun above 175 degrees. It melts the part very easily.