Review on Upgrade Your Electronics With Taiss Silver Tone Rotary Knobs For 6Mm Shaft - Set Of 10 by Ricardo Stewart
Not Quite 6mm - my new review
These knobs look great and feel very sturdy but sadly are not 6mm like it says. It may be 6mm without the brass insert, but these did not fit my pot shafts.I'm going to have to drill out the inside and hope it doesn't crack.
Pros
- Fit well, look great
Cons
- Limited functionality
New products
Comments (1)
July 20, 2023
This type of knob is useless without a setscrew. That is what you tighten to keep the knob from just spinning on the shaft! I received 10 knobs, no setscrews. I went to my local hardware store and paid 50 cents for one little set screw so I could at least use one of the knobs. Knob works perfect ... when you tighten the setscrew! Too bad the seller forgot to include the setscrews!Unbelievable. I have purchased many knobs like these over my many years. Never did I receive one that did not have the setscrew already in the knob.
Top products in 🧰 Passive Electronic Components
Precision Multi Turn Wirewound Potentiometer With A03 Knob (2Pcs) - 3590S Rotary Potentiometer 1K Ohm, 10-Turn Wire Wound - 3590S-2-102L
3.67
13 Review
25-Piece Radial Capacitor Set: 100V, 5% Accuracy, 0.0039UF Mylar Polyester Film
4
3 Review
2Pcs 10K Ohm Single Linear Taper Potentiometer With On/Off Switch & Aluminum Alloy Knob - TWTADE
4.28
4 Review
🔧 EDGELEC Precision Resistor with Multiple Tolerance Ratings
4
3 Review
