Review on 🖨️ PHROZEN Rapid Aqua-Ivory 4K Resin 3D Printer by Jonathan Bennett

PROS: - Prints SUPER fast - Solid parts are comfortable weight - Not brittle with proper post-curing (1-3 minutes in water) - Inexpensive CONS: - Very bad for detailed ones Models - Either too weak for light support or too exposed - Smells strong compared to the competition - More viscous than the competition - Slightly more expensive than the competition's fast resin. I have found that the ideal exposure time for capturing detail on my Creality resin printer (LD-002R) is around 3 seconds. It's insanely fast and the details will be perfect. But all supported models will fail at this exposure time. Especially pre-supported models that you can easily find on Patreon. This has also caused problems with models printed in multiple parts, as overexposure (to avoid crashes) causes them to mismatch. Screens, it's a great resin. However, if you need small details on models, this resin is not for you. Instead, I would go for the fast resin of the competition. It's cheaper, has less odor, and is highly recommended by many. I pretty much decide to use this to print simple bases for models. They require no support and no detail is lost due to the low exposure.