Review on 🚗 Auto Car Spark Plug Cable Ignition Wire Set of 4 for Chrysler Pt Cruiser 2001-2009 Sebring, Dodge 4 Cylinder | uxcell 671-4079 by Trendsetters Hare

Installed for 2005 PT Cruiser 2.4L I4 Customers with check engine light due to rough idle/accidental misfire/poor work. Another mechanic misdiagnosed a fuel pump failure which is a very expensive and unnecessary repair (noting here in case others get the same misdiagnosis). engine power. This uxcell 671-4079 Spark Plug Wire Set of 4 Plug Wires for 2001-2009 Chrysler PT Cruiser Sebring Dodge 4 Cylinders have 7mm diameter wires and are made to factory specifications. There is absolutely no benefit in spending more money on 8mm or so-called heavy duty wires as they add no additional benefit to spark performance. The exchange procedure is simple. Remove the six 8mm upper manifold mounting screws. Loosen the air intake clamp on the throttle body. Body. Lift the upper intake manifold and hold it with a bungee cord. It is really that easy. Remove the old connector cable. Using a Q-tip, apply a very small amount of dielectric grease to the inside of the trunk at each end (trunk only, not the terminal). Install a new connector cable. Repeat for each cylinder until finished. Lower the intake manifold into place and torque the bolts inside out to specification (no new gaskets needed). Tighten the clamp on the air inlet to the throttle body. Enjoy your new appearance! Of course, new spark plugs are also fitted, but this is another test of Autolite XP5263 Iridium XP Spark Plugs, 1 pack. Hope that helps!