Now I give the product 5 stars. BUT. All screws were mixed. the snap-on lid is of course plastic which doesn't fit tight enough that the screws won't go through the walls into the next compartment if the part is turned upside down and shaken during transport. My solution for this maker is to put a fairly small piece of styrofoam over the entire case before closing the lid and fill in the gap for any screws going through the walls. .now I have to go through 700 screws and disassemble them all
M.2 Screw Kit: Easy Mounting for NVMe SSDs on ASUS Motherboards
19 Review
MacBook Retina 13-inch (A1425, A1502) and π© 15-inch (A1398) Bottom Case Screw Set with Pentalobe Screwdriver
11 Review
Glarks 660 Pieces Phillips Assortment Motherboard
10 Review
Comprehensive 500pcs Laptop Screw Kit Set for π© IBM HP Dell Lenovo Samsung Sony Toshiba Gateway Acer
12 Review
Enhance Your Development Projects with the NVIDIA Jetson Nano Developer Kit (945-13450-0000-100)
12 Review
Complete Kuman Raspberry Pi 4B 3B+ Kit: Breadboard, Expansion Board, Jumper Cables, Ribbon Cable, Resistance Pack
9 Review
CZH-LABS Electronics-Salon Prototype Shield Kit for π οΈ Raspberry Pi - Ideal for Breadboard DIY Projects
13 Review
DSD TECH 2 PCS IIC OLED Display 0.91 Inch: Perfect Arduino ARM Accessory
9 Review