💻 711pcs PC Computer Screws Standoffs Assortment Kit for Hard Disk Drive, Computer Case, Motherboard, Fan, Power, Graphics by CO-RODE Review

To my disappointment I found that the container was damaged in transit and all the screws were mixed up. I had to sort all the screws by hand, which was tedious. I really hope they fix their packaging and maybe use thicker plastic for case strength.

Now I give the product 5 stars. BUT all the screws were mixed together. The snap-on lid is of course plastic, which doesn't fit tight enough that the screws won't go through the walls into the next compartment if the part is turned upside down and shaken during transport. My solution for the manufacturer is to put a fairly small piece of styrofoam over the entire case before closing. Cover by filling in the gap for any screws going through the walls. now i have to sort 700 screws and all…

The screws were of good quality. The plastic box was very cheap and the baffles didn't separate the screws. All screws ended with a divider.

I bought this kit because who doesn't need a good set of computer screws, separated and ready to use to have fun building a computer? I don't know if that's why lies that the product simply did not close the lid tightly enough to allow the items in the compartments to be separated, or whether it was the plastic bag it came in that allowed it to be crushed and caused the problem All I know is that I have a box of over 700 mixed pieces of junk, there's no way I'm going to be digging through these

Kit includes many of the most common fasteners plus a few tiny ones that are hard to find. The only weakness I see is that the bin dividers don't fit together very well, causing the fasteners at the bottom of the compartments to get mixed up. I'll put some silicone caulk on the bottom edge of the bays to get this out.

I'm sure all the screws are in place so they get 4 stars but the packaging/case is just terrible. The plastic case is so flimsy that it arrived bent, which confused all the screws in the box. Now I have to go over the 711 screws and reattach them. Let's talk about aggravation 😩

Don't buy this unless you want to spend all day going through all the hundreds of screws that are missing because of the fake cover on the box they came in were confused with each other. What a mess!

The kit contains many of the most common fasteners as well as some very hard to find small ones. The only weakness I see is that the bin dividers don't fit together very well, causing the fasteners at the bottom of the compartments to get mixed up. I'm going to put some silicone caulk on the bottom edge of the compartments to get this out.

Now I give the product 5 stars. BUT. All screws were mixed. the snap-on lid is of course plastic which doesn't fit tight enough that the screws won't go through the walls into the next compartment if the part is turned upside down and shaken during transport. My solution for this maker is to put a fairly small piece of styrofoam over the entire case before closing the lid and fill in the gap for any screws going through the walls. .now I have to go through 700 screws and disassemble them all

I bought this set because who doesn't need a good set of computer screws, all separated and ready to start building a computer?Try again I don't know if this is a product where the lid just doesn't seal enough is sold to keep the items in the compartments separate or is it the plastic bag it came in All I know is I have a box of over 700 sorted pieces of junk Over 700 pieces if I can't be sure they'll stay in their compartments or snap it shut the first time you pick them up, so it's pretty…