Review on 🚀 MOTOKU Turbo Boost Tap 2.0T FSI TSI MK5 GTI A3 A4 TT with Vacuum Sensor Adapter - Improved SEO by Dany Meadows

The kit included screws that were not used, the thread is not the same as on the faucet. Only 2 nuts worked on the faucet and the faucet extensions were cheap plastic that seemed to snap under any tension. The clip intended to hold the device was not strong and attached easily. Someone needs to develop a quality tap that is compatible with AN6-10 hoses. Instead I used Torque Solutions PCV Delete/Boost Cap. It has a very small single faucet compared to the large center faucet this unit has, so maybe not the best solution due to the diameter of the faucets, but it's the only thing that works for me when making some sort of fake part . I also use rtv when I put them on to make sure they fit well. Update: The Torque Solutions Boost cap didn't work well either so I had to go back to using factory tubing until I figured out what would work. The o-ring installation is the same as the factory connection and creates a poor vacuum connection.