Review on Printer 🖨️ Solidify Photosensitive Enclosure Solution by Darnell Murphy

After using this setup for the last week I have to say I really like it. I notice a faster and more even cure compared to just laying the prints out in the sun and the turntable is a nice addition. I'm not sure what the supplied power adapter is for, I'm guessing for other countries, but I haven't used it at all. I found this lid design for the Cults3D print "Resin Curing Paint Can Lid" which is perfect for UV lamps. I bought a 1 gallon can of paint at a local hardware store and wrapped it in foil tape. The platter fits in nicely, leaving enough room for my Anycubic Photon prints. With the lamp in this position, the turntable's solar function gets more than enough power and moves quite quickly. With this setting I recommend drying for 3 minutes and then turning the prints over for another 3 minutes to ensure they are fully cured on all sides.