Printer 🖨️ Solidify Photosensitive Enclosure Solution Review

First, it takes 30 minutes to build a protective box lined on all sides with aluminum foil, cut a hole and put a light on it. this works better but still takes time but takes more, it's sticky but i placed it with a heat source and kept drying it, it doesn't really work with shapes that aren't transparent and it seems thicker when the coverage with keychains is better. Dry top coat only so I left them after an hour, no problems with resin, more black light, 6 wyatt why

turntable is junk. It doesn't have an on/off switch and every time you want to turn it off you have to remove the battery. The battery compartment is not standard and the battery is difficult to pull out. light works. Treatment takes longer than most people think. 3-4 minutes on each side. I've found that I need 15 minutes per side to heal the casts well. Besides, he does what he has to do. Personally, I would advise taking the one without the player.

After using this setup for the last week I have to say I really like it. I notice a faster and more even cure compared to just laying the prints out in the sun and the turntable is a nice addition. I'm not sure what the supplied power adapter is for, I'm guessing for other countries, but I haven't used it at all. I found this lid design for the Cults3D print "Resin Curing Paint Can Lid" which is perfect for UV lamps. I bought a 1 gallon can of paint at a local hardware store and wrapped it in…