Header banner
Revain logoHome Page
Ronny Welch photo
1 Level
1339 Review
74 Karma

Review on SUNLU 3D Printer Filament PLA Meta 1.75Mm, 100% Neatly Wound 2.2Lbs Spool For Most FDM Printers, High Speed Printing With Dimensional Accuracy +/- 0.02 Mm - Red by Ronny Welch

Revainrating 5 out of 5

I hate to say I actually like this stuff for objects that won’t get handled much.

This PLA meta printed extremely well and had excellent layer adhesion. Filament that is easy to tune (didn’t take much to dial in) with the low temp range. I printed a 10” Darth Vader model that took almost 55 hours without a single defect!Definitely recommend this style of filament for beginners getting their first experience with printing. The low cost and ease of printing makes this a great filament choice. The only thing I wasn’t crazy about was of course the low melt point, as it would deform and warp a bit to easily for me. I forgot this is much softer than regular PLA, and I tried to remove a finished part at a few minutes after print was done and I noticed how soft and easily deformed the walls were. I just need to wait a little longer to pull off a warm bed. Great filament for ease of printing!

img 1 attached to SUNLU 3D Printer Filament PLA Meta 1.75Mm, 100% Neatly Wound 2.2Lbs Spool For Most FDM Printers, High Speed Printing With Dimensional Accuracy +/- 0.02 Mm - Red review by Ronny Welch



Pros
  • Worked great love it
Cons
  • May produce more waste than other filaments