Review on 🔧 Efficient Round Over Edging Router Bit for Smooth Finishes by Eric Smithlin

I make furniture to order. I needed a 3/4 round cutter and bought Yonico. Milling Tigerwood left a 0.011 inch thick overcut edge on the bearing surface. This is a manufacturing defect. Either the bearing is too small or the cutting blades have been ground too large. I had to sand down the burr it left and then figure out how to get the flush finish. I spit out my nails. I could live with an undercut (not a true 3/4 radius), but not an overcut. I will not buy another Yonico. I would rate this as a minus, but Revain has no such choice.