Review on 🖨️ AMOLEN Shiny Printer Filament 1.75mm by Alex Jones

There are a few other threads from this brand that work well but for some reason this blue/silver just doesn't stick. It acted like it needed more heat, even at 220/75C it didn't stick at all. I tried a hairspray I never use, the bottom layer started to stick and then peeled off like it was too cold. It also seems to be thinner than the multicolored glow I switched to after that, which has held up well without any modifications and normal PLA temp. Either I have a bad batch, or it takes a lot more heat to bond than intended.