Review on πΊ MakerFocus 1.5inch OLED Display Module 128x128 Pixel SSD1327 - SPI/I2C Interface, 16-bit Grey Level - for Ar duino/Raspberry/Jetson Nano/STM32 - DC 3.3V / 5V by Barbara Evans
Note the Vcc/Gnd pin placement
I ordered these OLEDs for use on a TTGO T board but I didn't notice the Vcc/Gnd pins in relation to what is needed are reversed on the T-board. my fault I had to cut the power/ground connections to swap them out. In general, OLED boards are very good. If the contacts are in the right place or it doesn't matter to your project, this is a great prize.
- Same as everything so far
- No form required
New products
Comments (0)
Top products in π₯οΈ. Single Board Computers
Vilros Raspberry Pi 4 4GB Complete Starter Kit - Black Fan-Cooled Aluminum Case for Heavy-Duty Performance
12 Review
55" TV LG OLED55C2RLA 2022 HDR, OLED, dark titanium
38 Review
REXQualis Comprehensive Starter Kit with Arduino MEGA 2560 & Detailed Tutorial for Arduino IDE Compatibility
11 Review
π Ultimate BBC Micro bit Sensor Starter Kit: Keyestudio 37-in-1 Box with Tutorial, Compatible with V1.5 & V2, Gift for Kids and Adults (Microbit Board Not Included)
11 Review
Another interesting products
uxcell 3.5" HDD Screw Black 200pcs for Computer PC Case - Flat Phillips Head - 6#-32 - Hard Drive Fasteners
10 Review
36-Pack Black Rubber PC CPU/Case Fan Screws/Rivets Set for Computer
11 Review
MacBook Retina 13-inch (A1425, A1502) and π© 15-inch (A1398) Bottom Case Screw Set with Pentalobe Screwdriver
11 Review
M.2 Screw Kit: Easy Mounting for NVMe SSDs on ASUS Motherboards
19 Review