I have an outer tube bib that I need to replace. The hose bib is slightly off center on this side block and I can't move it due to some internal piping so I have to live with the pipe being off center on this block. I sanded the front of the block and the back of the trim with 80 grit sandpaper and epoxy sanded a piece of trim that matches my house on this block to cover the center holes, allowing my new bib to slide slightly off the center of the Holes removed this siding block is not shown. The photo shows the approximate position of the new bib relative to the block. If I leave the holes open with a piece of siding that I've sealed with epoxy, the factory holes will show and it will look crappy. If this white facade block had a solid surface, it would not be a problem. Hope that helps!
Bonvoisin Hydraulic Hand Pump Manual Ram Pump 8500Psi Porta Power Pump For Hydraulic Tools(CP-180)
4 Review
BFGoodrich g-Force Stud 215/60 R16 99Q winter
73 Review
Nokian Tires Hakkapeliitta 9 SUV 225/55 R18 102T winter
6 Review
π’ Bonvoisin Shipbuilding Machinery: Advanced Hydraulic Cylinder Technology
4 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
Vacuum cleaner Dreame V9 Global, white
145 Review
1 Inch Beduan Brass Electric Solenoid Valve, 12V Normally Closed Air Valve For Water, Gas, Fuel, And Oil
10 Review
Joywayus 5/8" ID Hose Barb Hex Union Brass Fitting Water/Fuel/Air With 10 Stainless Steel Clamps (Pack Of 5)
13 Review