Review on 🔧 Versatile and Convenient: Sargent Art 22 2000 2 Pound Resealable Crafting Solution by Carrie Spencer

Container with mold and cracks. I ordered 4 tubs and 3 of them were moldy. I received 4 replacement tubs very promptly, but 3 of the 4 were also moldy and two containers were cracked. There seems to be a bad batch of these currently as another reviewer had the same issue. I hope this gets resolved soon! My 2 stars relate to moldy and cracked tubs. This product is actually the best available for non-air set clay IF properly stored and used. The lid must be completely closed - very tight around the entire perimeter. It's easy to accidentally under-tighten. The pieces combine well with water and a little "smoothing". After about 24 hours it is dry and hard. It breaks if dropped so it's a bit delicate but that's to be expected from a product like this. Painting with acrylic paints additionally seals the tone and nozzles. Adding sticky glue to the joints also helps when there doesn't seem to be enough water. Sculpt-it clay cylinders should be kept in an airtight container until ready to use and then used immediately. If the container is left open for even 20-30 minutes, it will begin to harden and become more difficult to use. that there is not enough water. Sculpt-it clay cylinders should be kept in an airtight container until ready to use and then used immediately. If the container is left open for even 20-30 minutes, it begins to harden and becomes more difficult to use. that there is not enough water. Sculpt-it clay cylinders should be kept in an airtight container until ready to use and then used immediately. If the container is left open for even 20-30 minutes, it will begin to harden and become more difficult to use.