Review on Beech Lane Upgraded Performance Conditions by Jose Mcdaniel

Beechline Valve Replacement Kit works. It's almost impossible to find a good video on how to properly replace a part, so here are the key points that may not be immediately obvious. Before installing, make sure the top of the valve with the black o-ring is inside the top of the main valve body. (See pictures).2. The easiest way to replace the part is to remove the toilet and remove the Flush Access Panel (FMAP) from the top of the toilet. This will allow access to the spray arm spring wire to be connected to the new valve. You need to loosen the 4 screws holding the FMAP in place.3. After removing the FMAP, disconnect the spring cable from the toilet.4. Before installing a new valve, thread the correct end of the spring wire through the hole and valve lever.5. With the valve body positioned for installation at the rear top of the toilet, pull the spring wire back toward the flush lever.6. Push the valve body into place. The orange O-ring will help keep the valve in place.7. Insert the end of the spring wire back into the base of the rinse arm (looks like a small wheel with a spring)8. Screw the valve body to the toilet with the screws provided.9. Screw the FMAP back to the toilet with the 4 screws removed.10. Optional (replace the toilet gasket at the bottom of the toilet. You can also do this) 11. Check the flush lever to make sure it is tightening the spring wire on the new valve.12. Reinstall the toilet 13. Connect the water supply and check everything.