Review on 🌟 ERYONE Sparkling Glitter PLA Filament: Enhancing Quality for Additive Manufacturing Products by Julian Davidson

Thread and prints look great. It prints well at 210c including a photo with a layer height of 0.2mm, it's a small print and the camera contrast increases dramatically so layers are visible but that's not true. In her opinion, the thread shimmers and, from a reasonable distance, completely covers the lines of the layers, and since it is transparent with sparkles, it looks amazing. However, I will say it is clear that the filament has been misstored and kept in a warehouse at high temperatures as the filament appears to be hanging on the spool, bending and warping which could cause a lot of friction with Bowden systems like this Ender 3. But it worked fine on my direct drive car. It also caused it to slip off the reel unpredictably and create tangles that destroyed the print. But when it prints, it's just amazing. After using more roll I had a few blockages. I've had no problems with the 0.6mm nozzle, but since switching to 0.4mm I've been getting clogged every few hours.