Review on Industrial Anti-Skid Surface with Momentary Grip - URBEST by Michael Glassburn

The wiring does not match the diagram on the bottom of the switch. Not even remotely. It was easy enough to fix. The switch moves too easily as it is plastic and lightweight. I found a way to attach it to a small metal base. In addition to improper wiring and light weight, the switch is oversized. Even after mounting on a metal base. It works flawlessly and for the price I'm willing to put up with a few small hiccups. If someone else runs into a wiring issue and feels smart enough to fix it themselves, here's how to remove the top: Remove the small screw from the bottom. Then use a small punch or screwdriver and a small hammer and gently tap out the hinge pin in both directions. You'll find that the wrong wiring is soldered on but did very little good. This made it easier to re-solder or, if desired, crimp some of the spade terminals. I have not reused the pen. Instead I used two screws with the same diameter as the pin. One on each side.