Before going below deck to install this fitting I did a test fit on some short pieces of PVC. Its installation was not easy.1 . Loosen the clamps to allow the rubber to expand. It really expands to a good bit.2. Wipe the PVC pipes with a damp cloth. And mark the PVC pipes with a pencil line about 1.5 to 2 inches from the end so you can see when the pipe is fully installed. Apply some liquid dish soap to the inside of the rubber fitting.4. Center and insert the PVC. Make sure it goes all the way in, then push it all the way in using the depth marks.5. Tighten the clamps. I used a socket wrench and checked the tightness by twisting the tube.
Vacuum cleaner Dreame V9 Global, white
145 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
Upgrade Your Draft Beer Kegerator With The TerraBloom CO2 Keg Pressure Regulator - Dual Gauge Heavy Duty Unit With Safety Features
16 Review
Joywayus 5/8" ID Hose Barb Hex Union Brass Fitting Water/Fuel/Air With 10 Stainless Steel Clamps (Pack Of 5)
13 Review
π§ Thermoplastic Aluminum Fitting Equipment by SAFBY
3 Review
Flexaust 611S Polystyrene Cleaning Crevice: Versatile and Efficient Solution for Deep Cleaning
4 Review
Ultimate Performance: SpringSpray Aluminum Equipment Heavy Duty Industrial for Optimum Productivity
3 Review
Fill Rite 5200F1790 Nozzle Spout Threads
3 Review