5. Where there is a basket for HDD and PSU, there is catastrophically little space. By the way, I could not stick my relatively small PSU with wires there. The wires rested on the HDD basket. I had to remove the HDD basket to put the PSU through. There are very few places. Everything is close to each other. And about the HDD basket - a different story. 6. The HDD bin is just awful. It is screwed from below to the body through bolts between which rubber gaskets pass, which are not very good in quality. Quite soft and doesn't seem to dampen vibrations. They should be 2 times tougher. Foolishly, I read the instructions inattentively. I thought the basket is removed by unscrewing the bolts. He began to unscrew one bolt - he scrolled a little and stood up, as if rooted to the spot. I thought maybe the factory did it that way. Began to twist the second - it stands rooted to the spot. The third one came off easily. Then I thought that something was not right, for even more effort and the thread on the bolt head would start to deteriorate. It turned out that it was only necessary to loosen the bolts a little and pull towards you so that it would move out of the narrow grooves and move into looser ones, after which it should be removed. Be careful. That third bolt, which was unscrewed, is now not tightened tightly, not straight up to the stop, as it was from the factory (the thread came off at the basket itself). That's the quality. When I removed the basket from the fourth bolt on the elastic band, a small piece fell off. This is again about the quality of these rubber bands. 7. Rubber feet on the bottom of the case - disgusting. The same soft material, and even thin. When he collected, he strongly doubted that he could extinguish something. Firstly, Zalman's legs were 3-5 times thicker, and secondly, they didnโt push through like that, they were really hard. After assembling the aerocule and the first launch, it turned out that the vibrations from the HDD are greater than on the Zalman Z11. Feels like 1.5-2 times. Which really pissed me off. I think now to buy normal rubber pads and finish the legs, because this is PPC. I'll finish in the comments