Header banner
Revain logoHome Page
Andrew Grant photo
1 Level
1312 Review
60 Karma

Review on πŸ”Œ iKKEGOL 16 Pin J1962 OBD2 OBD-II Male Connector to Open Plug Wire, OBD Diagnostic Extension Cable Pigtail - DIY (60cm, 24 inch, 2ft) by Andrew Grant

Revainrating 1 out of 5

SMALL wires, wrong pinout

Now I have to manually check ALL the pinouts. There was no further information on the finds other than the photo in this listing/description. This tiny wire is VERY difficult to work with. I would suggest that you solder and heat shrink ALL the connections with this thin wire. Use a good quality ceramic soldering iron and be VERY careful with the temperature. This little wire can burn out if you are inexperienced. I have homemade OBD connectors and am using them in this project instead, which is a shame as this one has a cable protector.

Pros
  • Nice to use
Cons
  • Secret