I bought this cabinet based on a recommendation from another reviewer. The wardrobe is of good quality. Mine had two big problems. A half shelf (brackets on the side) completely rusted. I had to sandblast and repaint. The fan that was on was ridiculously loud. I replaced the fan with an AC Infinity AXIAL LS1238, Quiet Muffin Fan, 120 VAC, 120mm x 38mm, Slow Fan. (The fan I bought was still a little louder than I wanted. If I were to do it again, I'd buy a variable speed fan.) So those two things reduced the star count, not the changes needed . If you want to install the Ubiquiti Unifi 150W 8 port switch, it will not fit without major modifications to the housing. The inside dimensions are too small for the switch. The width is too narrow to install the switch even if the mounting plates are offset to the outside of the rails. Even after this change, the inner cabinet was too narrow to accommodate a switch. It had to enter at an angle and be located behind the mounting plate. If I had another 1/8 inch it would fit. Another user was able to assemble it, so this may be a quality control issue when the cabinet is made. Another problem I found was that the cabinet wasn't deep enough for the switch. The power cord prevents the switch from fully entering the closet. I had to purchase a right angle power cord (CableCreation 3ft 18AWG Universal Power Cord for NEMA 5-15P to IEC320 C13 Angled Cord 3ft/Black). I also have both SFP ports in use which caused the door to not close. To do this work, I used a dremel to cut out slots in the rear mounting plates to allow the switch to slide further into the cabinet (with the power cord at a right angle). I also made cuts on the front mounting plates to move them outside of the rails. This gave me almost enough width, but was still about 1/8 inch less, but just enough to tilt the switch at an angle and place it behind the mounting plates. I also drilled holes in the front panels to install the switch. With these modifications I was able to do this work. The door closes, but barely. The glass only touches the wiring. I also made $5 sheet aluminum shelves that I bought at a local hardware store. I attached them to the half shelves with a flat steel bar I had. The cabinet fits Unifi switches but with more modifications.
Wall mount ONKRON TM1 for TV 17"-43", inclined, up to 30 kg, black
13 Review
📦 Enhance Your Rack System with NavePoint Universal Rack Tray Vented Shelves 1U Black 10 Inches (250mm deep) - No Lip
10 Review
🔩 Lancher 60-Pack Black Cage Nuts and Screws for Server Rack Mounts - M6 x 16mm - 1U, 2U, 6U, 12U Cabinets and Shelves
11 Review
NavePoint 12U Wall Mount Network Server Cabinet Rack Enclosure with Glass Door and Locking Mechanism
10 Review
Renewed Logitech G PRO X Wireless Lightspeed Gaming Headset with Blue VO!CE Mic Filter for Immersive Gaming Experience
122 Review
Sennheiser PC 8 2 Cancelling Microphone
71 Review
🎥 Logitech C270 Webcam: Crystal Clear Video and Superior Quality
183 Review
Apple AirPods Pro MagSafe RU Wireless Headphones, White
159 Review