Just installed a 2015 Mazda 3. Existing holes and rivets in the wheelhouse used for the front end. Aligning the drill holes is a bit tricky. I put a small pin in the hole, "knocked out", then drilled a mark. I then measured the second hole in relation to the first on the paper template and transferred it to the fender. It took a bit of effort to line up the second hole but I managed it, great. I drilled mirror holes for the second front wheel. The rear was a problem. There are no existing holes or rivets in the wheel arch. However, there are holes under the rear bumper. At these points I drilled two holes. Additional rivets must be purchased separately. I bought a pack of "Universal" clips/rivets. I like her best. I'm planning an upgrade but they look great!
SuperJump Trampoline with SuperJump 8ft (244 cm) net and ladder
29 Review
4WD ORCISH Recovery Traction Boards Tracks Tire Ladder For Sand Snow Mud - Set Of 2 (2Nd Gen Bag + Mounting Pins, Black)
39 Review
Cordiant Road Runner 195/65 R15 91H summer
24 Review
Get Ultimate Towing Stability With CURT TruTrack Weight Distribution Hitch & Sway Control - Up To 10K Capacity, 2-Inch Shank & 2-5/16-Inch Ball - In Sleek Black Design
30 Review