Review on WORX WX051 Pegasus: The Ultimate Folding Work Table & Sawhorse for Every Handyman by Mateusz Sowa ᠌

1. The unfolded surface without additional makeshift supports will always be a "slide" due to the assembly curve. A small slide is given not only by the wings, but also by the ends of the supports, which make up the main stiffener of the workbench in the working position. But this is really not much, up to 2 mm per end thickness, i. E. due to the mobility of the plastic under load, it is leveled. 2. The wings of the workbench play slightly up and down on the struts. In principle, this jamb can be used in order to use additional supports for some work: there will just be an emphasis on regular 4 legs, and on additional. support. 3. Workbench, if used as a universal one, requires the use of additional countertops due to the excessive thickness of the edges, and they are immediately followed by deep voids, as well as due to the insufficient strength of large areas on the work surface where the stiffening ribs are cut. Of course, these zones are not marked in any way. Of course, all layouts and samples of countertops (at least 2 of them are needed) should be done by the user himself. For what? - because without them, even a stand with an engraver cannot be screwed to the edge so that it does not interfere. 4. Here too: the workbench does not allow side mounting of any tool that requires a strong base for itself. There is nowhere to put even a stupid clamp for a conventional drill, if not right under your arm. Well, at least under the left. 5. recesses for small items are located under the right hand, if you work while sitting. It's ketai, baby :( 6. Wing supports are just tubes of Chinese iron, thin pins and dumb loops at the points of attachment to the tabletop. Apparently, the Chinese god does not allow to do according to the mind.